cnPilot Enterprise AP
User Guide
CAMBIUM
NETWORKS
18
System Configuration
This section describes the System, Management, Time Settings, and Event Logging functionalities
of cnPilot Enterprise AP.
System
The following table lists the fields that are displayed in the Configuration > System page:
Table 1: Configuration: System parameters
Parameter
Description
Default Value
Name
Hostname of the device. The
maximum length of name is
64 characters.
─
Location
The location where the device is placed. The
maximum
length of location is 64 characters.
─
Contact
Contact information for the device.
─
Country-Code
To be set by the administrator to the country-of-operation
of the device. The allowed operating channels and the
transmit power levels on those channels depends on the
country of operation. Radios remain disabled unless this is
set. The list of countries supported depends on the SKU of
the device (FCC, ROW etc).
─
PoE Output
(Only for ePMP
1000 Hotspot)
Enable to make the AP provide power an auxiliary device
connected to its ETH2 interface. Note that the Eth2
interface provides Cambium PoE (not standard 802.3af) and
only supported Cambium devices should be plugged into
that port, when POE-Out is enabled (devices such as other
ePMPs, PMP450-SM).
─
LED
Select the LED checkbox for the device LEDs to be
ON
during operation.
─
You can configure the above parameters through the UI or CLI.
In the UI
1. Navigate to the
Configuration > System
tab. The following fields are displayed in
System
:
a. Enter the hostname of the device in the
Name
text box.
b. Enter the location where this device is placed in the
Location
text box.
c. Enter the contact details of the device is placed in the
Contact
text box.
d. Select the appropriate country code for the regulatory configuration from the
Country-Code
text
box.
