C3VoIP-150 Installation Manual
C3VoIP-150 Installation Manual
3. Installation
This chapter explains the installation procedure of C3VOIP-150.
3.1
Connection topography
3.2
Installation Steps
1.
Insert one end of the Ethernet cable into the Radio port at the back of the C3VOIP-150
and the other end into the cable that leads to the PMP remote radio module
Note:
Please refer to one of the SM installation guide(s) for information on how to install your SM.
2.
Connect the LAN port at the back of C3VOIP-150 to your conventional telephone, using
a standard phone cable
3.
If there is a need to setup a small LAN network at home, the C3VOIP-150 must work in
router or bridge mode so that users can access to the Internet through C3VOIP-150. Then
you must connect your PC or LAN connection equipment (e.g. Ethernet switch or Wi-Fi
router) to the LAN port at the back of the C3VOIP-150 using an Ethernet cable. (Step 3 is
optional and depends on your needs)
4.
Connect the power adapter to the power port at the back of C3VOIP-150 and then plug
the power adapter into a wall outlet or power strip. The Power LED of C3VOIP-150
glows to indicate the correct operation. Once the SM is powered on, it may take some
time for it to register onto the AP and provide the INTERNET service.
Warning:
Do not attempt to use different power adapters or cut off power supplies during configuration or updating
C3VOIP-150 VoIP ATA Gateway. Using other different adapter can damage C3VOIP-150 VoIP Gateway and
void the manufacturer warranty.
Warning:
If there is a power outage, E-911 WILL NOT Work.
