PTP 820C Quick Start Guide
Page 7
To connect a DC power cable
Strip off 45 mm from the
cable jacket and expose
10 mm at the edge of
each of the two wires.
Remove the gland cap
and rubber from the
gland body
Insert the power
cable into the gland.
Insert the power cable wires
into the power connector.
Match “+” to the 0V wire and
“-“ to the -48V wire.
Plug the power cable
with connector into the
PTP 820C power
connector.
Hand-tighten the gland to the radio
unit until there is full contact
between the gland and the radio
unit and hand-tighten the gland cap.
Secure the cable to the
gland using a tie wrap.
1
2
3
4
5
6
7
8
Tighten the
two top
screws.
Tighten the two
front screws.
9
