PTP 820C Quick Start Guide
Page 20
Link Verification
Verify that the Received Signal
Level (RSL) is up to +/- 3 dB from
the expected (calculated) level at
both ends of the link.
You can measure the RSL at the
BNC port indicated in the figure to
the left. The voltage at the BNC
port is 1.XX where XX is the RSL
level. For example: 1.59V means
an RSL of -59 dBm. Note that the
voltage measured at the BNC port
is not accurate and should be
used only as an aid).
Verify that the Radio Bit
Error Rate (BER) is 10E-11
or higher.
If working with ATPC, verify that
ATPC is operating as expected
(RSL = reference level).
To display the BER using the Web EMS,
go to the Aggregate PM report (
Radio >
PM & Statistics > Aggregate
).
To display the current RSL (RX)
using the Web EMS, go to the
Radio Parameters page (
Radio >
Radio Parameters
).
To display the RSL PMs using the Web
EMS, go to the Radio Parameters page
(
Radio > PM & Statistics > Signal Level
).
