cam REGOLO ISOFIX, Instructions For Use Manual

Page: 28 / 96

27
the car seat harness, must be adjusted correctly to fit the childs body. ensure
the the belts are not twisted in any way! • pay attention to the fitting of the
abdominal belt, ensuring that it is positioned low down, to ensure that the pelvis
is held firm and correctly protected. • even when travelling without a child, the
car seat must be fully restrained at all times. • Do not use the car seat without the
fabric upholstery covering. • the fabric upholstery must not be replaced with any
other than original parts, or those recommended by the manufacturer, as this
constitutes an integral part of the restraining system. • the upholstery can be
washed in warm water (max 30°), with a mild neutral detergent. Do not tumble
dry, do not iron, and do not use solvents. • Should any problems arise during the
fitting, or use of this product, contact the manufacturer. • please note that group
1-2-3 stage car seats can be used on the front seat and are exempt from the
regulation of not being fitted when an airbag is active, as per Regulation ece R 44.
We would however recommend that this car seat only be used on the rear seat of
your vehicle. • For safety reasons, this instruction booklet, must be kept in the
pocket situated at the rear of the car seat at all times. • Use of the car seat is
subject to standard ece R 44. certain limitations prevail over this standard and
are imposed by local or national laws.
INSTRUCTIONS FOR USE
INSTRUCTIONS FOR USE
Fitting the child safety seat with the
car’s own three-point seat belt (art.162)
1. the child safety seat can be fitted on all
the seats shown in the diagram (only if
point 2 is complied with).
NB:
although
standard ece R44 allows the use of child
safety seats in groups 1-2-3 on front
seats provided with airbags, it is advisable
to fit them only on rear seats .
2. the child safety seat can only be fitted
on seats equipped with three-point seat
belts that comply with standard ece R16
or an equivalent standard (fig. 2a-2). NB : it
is advisable to move the passenger seat
forward to prevent the child from hitting it
(fig. 2b).
3. place the child safety seat on the car seat
taking care to position it correctly (fig. 3a-
1). CAUTION: avoid the incorrect fittings
shown in fig. 3A-2.
4. to facilitate subsequent operations,
recline the seat using lever “l” as shown in
the figure. For further details on how the
reclining action works, see point 25 and
the relevant diagrams.
5. Diagram of the compulsory routing of
the car seat belt.
6.7.8. Fitting the child safety seat with the
car seat belt: follow the sequence
illustrated.
CAUTION: at the end of the operations,
check that the belts are taut and
positioned correctly.
DESCRIPTION of the child safety seat
with the ISOFIX UNIVERSAL system
(art.163)
9. the child safety seat is fitted with an
iSoFiX universal system to anchor it to the
car in the category or class b1. the
components shown in the figure are
required for fitting and regulating the
iSoFiX system.
N.B.: if necessary, use the
optional centring adapters “p”, as shown in
the figure.
FITTING the child safety seat with the
ISOFIX UNIVERSAL system
(art.163)
10. introduction to some of the recurrent
symbols:
10A. Read the child safety seat instruction
manual with care.
10B. Read the car instruction manual with
care.
10C. indicates that the child safety seat is
fitted with the iSoFiX system (according to
ece 44).
REGOLO 23 novembre 2016_Layout 1 25/11/16 09:10 Pagina 28