28/40
5. Check bolts and screws
Check that all the screws are properly tightened and check the lifting device attachment hooks.
In case of damage or loose bolts/screws, replace/tighten them.
Check that fork locking pins and end bar keepers are installed and functional.
Check sample of base plate cap screws for proper torque value.
Check sample of bearing cap screws for proper torque value.
Tighten lower mounting hook cap screws to 165 Nm.
Inspect forks, carriage bars and frame for cracks and wear. Replace components as required.
Fork bar – if equipped, tighten cap screws to: ISO 2A, 145 Nm
This can be done by the user.
After completing any maintenance service procedure, always test the attachment through five
complete cycles.
First, test without the load, then test with a load to make sure the attachment operates
correctly before returning to service
6. Lubrication
Perform a complete lubrication, grease the points indicated in the figure below.
Rotate 90° and grease in each position.
HF-TS
HFR-TS
Summary of Contents for HF-T Series
Page 32: ...32 40 11 ANNEXES 11 1 CE certificate...
Page 33: ...33 40...
Page 38: ...38 40 NOTES...
Page 39: ...39 40 NOTES...
