20/40
9. Connect the hydraulics
10. Your fork clamp is now ready for use!
For correct operation, the fork clamp requires an oil flow rate of 25 l/min at a maximum pressure
of 180 bar.
A flow rate lower than recommended will result in a lower rotational speed.
A flow rate higher than the maximum may result in overheating, reduced system performance
and shortened hydraulic system life.
After the assembly of the attachment and before putting the device into operation, check if all
the functions operate correctly.
Any failure of the safety devices can cause malfunctioning and damage to the attachment.
5.3.1. Bleeding the hydraulic system
To avoid air from entering your hydraulic system, which could eventually cause damage to the fork
clamp, it’s necessary to bleed the hydraulic system before use.
1. Start your lifting device.
2. rotate or move your fork clamp several times in both directions.
3. Inspect the hydraulic circuit for any leaks
HFR-TS
ROTATION
JOINT
SIDESHIFTING
OPEN-CLOSE
FORKS
HFR-TS
Summary of Contents for HF-T Series
Page 32: ...32 40 11 ANNEXES 11 1 CE certificate...
Page 33: ...33 40...
Page 38: ...38 40 NOTES...
Page 39: ...39 40 NOTES...
