23
Clear Alert
STATION ALERTS
09/02 11:52PM
NO CURRENT for Stn 1
09/04 11:53PM
NO FLOW Stn 1 @ 0.0 gpm
09/08 11:50PM
NO FLOW Stn 1 @ 0.0 gpm
09/08 11:50PM
NO CURRENT for Stn 1
------
09/04 11:55PM
NO FLOW Stn 2 @ 0.0 gpm
09/08 11:55PM
NO FLOW Stn 2 @ 0.0 gpm
09/10 11:54PM
NO CURRENT for Stn 2
09/12 11:54PM
NO CURRENT for Stn 2
------
09/04 11:58PM
SHORTED OUTPUT Stn 3
From the Controller Status screen, Press the
STATION ALERTS
Menu Key to view the Station Alerts screen (shown above).
From the Station Alerts screen you can view and clear any station alerts that have occurred. All alerts that have occurred since
the last time they were cleared will be shown, a dashed line will separate each valve. Press the
PLUS
or
MINUS
Key to scroll up
or down to view more alerts if necessary.
Station Alerts tell you what problems the controller has detected during irrigation cycles. Some examples of station alerts are
“High Flow” which indicate possible broken heads or broken pipes, “No Flow” which indicate possible valve problems, “Shorted
Output” and “No Currents” to indicate possible wiring or solenoid problems.
17. Weather Setup
From the Main Menu Press the
WEATHER
Menu Key, the Weather Setup screen will appear (shown above). From the Weather
Setup screen you can access the setup of any optional Calsense equipment (if the option is installed on the controller) which
includes the Calsense ET Gage, Rain Bucket, and Wind Gage, also a rain switch if one is installed. You can also access the
setup of daily-ET, water budgets and moisture sensors. The following sections describe Rain Bucket settings on a controller without
the -RB interface, Wind Gage setup, Rain Switch setup and Moisture Sensor Setup
(setup of the ET Gage and the Rain Bucket
on a controller with the -RB interface, is explained in the Calsense ET Based Water Management Guide)
.
Rain Bucket Settings
Press the
RAIN BUCKET
Menu Key, the Rain Bucket Setup screen will appear as shown below if the controller does not have
the -RB interface installed. The only way rain can be used to offset irrigation for a controller that is not connected to a Rain Bucket,
is by sharing rain data using the Calsense Command Center program. If you are not sharing rain data, the setting described here
will have no affect on irrigation.
ET
Rain Switch
Budget
Moisture
WEATHER SETUP
ET Gage
Rain Bucket
Wind Gage
Optional Equipment Menu Keys
(available only if option is installed)
Station Alerts
RAIN BUCKET SETUP
Rain Bucket controllers have 3 more
settings. This controller does not
have a -RB interface.
Let Rain Only Build up to inches
1.50
Set Use of Rain by Program
Press the
PLUS
or
MINUS
Key to set the maximum amount of rain allowed to be used to offset irrigation. Press the
SET USE
OF RAIN BY PROGRAM
Menu Key to access the Use Of Rain By Program screen (shown on the next page).
