16
How to Connect your LP gas cylinder (See STEP 9 of Assembly
Instructions for diagram)
1) Make sure all of the control panel knobs are turned to the
“off” position and verify that the LP gas cylinder valve is
closed by turning the handle on the LP gas cylinder
valve clockwise until it stops.
2) Remove the protective cap from the LP cylinder gas
nozzle.
3) Hold regulator in a straight line with LP cylinder gas
nozzle so the connection does not cross thread.
4) Insert nipple into the LP cylinder nozzle opening.
5) Hand tighten coupling nut in a clockwise direction.
Do not use tools.
6) Perform a Leak Test. (See STEP 10 of Assembly
Instructions for Leak Test Instructions)
How to Disconnect your LP gas cylinder
1) Turn all control knobs to the “off” position and turn the
handle on the LP gas cylinder valve clockwise until it stops.
2) Turn coupling nut on regulator in a counter-clockwise
direction until regulator is released from threaded LP
cylinder gas nozzle.
3) Place the protective cap over LP cylinder gas nozzle.
BEFORE USING YOUR
LP GAS GRILL
Do not use an LP gas grill indoors, on recreational
vehicles, or on a boat.
· This LP gas grill is for outdoor use only and should be
placed on firm, level surface. The grill should be used in
an open area with good ventilation, away from high traffic
areas and combustible materials.
· Combustible or flammable materials should never be
used or stored within 36 inches of the back or sides of
your LP gas grill.
· Locate your LP gas grill at least 10 feet away from your
house or any building. Do not use the grill in a garage,
breezeway, carport, porch, or under a surface that can
catch fire.
· When moving your gas grill, you should push the grill in
front of you with both hands on the side table. Make sure the
hood is closed and push grill slowly.
· Carefully read the Important Safeguards section
of this manual (pages 2 thru 4). Make sure you
follow and understand all instructions and warn-
ings. If you have any questions regarding these
pages, call 1-800-251-7558 and ask for a
Customer Service Representative.
· This installation must conform with local codes or, in
the absence of local codes, with either the National
Fuel Gas Code, ANSI Z223.1, or CAN/CGA-B149.2,
Propane Installation Code.
· If an external electrical source is utilized, the outdoor
cooking appliance, when installed, must be
electrically grounded in accordance with local codes
or, in the absence of local codes, with the National
Electrical Codes, ANSI/NFPA 70, or the Canadian
Electrical Code, CSA C22.1.
· If any electric appliance or rotisserie is used with the
LP gas grill, do not allow cords to touch or be near hot
surfaces. Electric cords should be placed away from
walkways to avoid a tripping hazard.
· If using a Grill storage cover, it must be removed and
placed at least 36 inches from the LP gas grill while in
use. Grill covers are made of flammable materials.
The grill must be completely cooled before putting
the cover back on the grill.
· Never store a spare or disconnected LP gas cylinder
under or near this LP gas grill.
· Inspect the hose and regulator assembly before each
use. If the hose is cut or damaged or shows signs of
excessive abrasion or wear, do not use the LP gas
grill. Contact the manufacturer, as the hose must be
replaced with an assembly specified by the
manufacturer prior to further use of LP gas grill.
· Use only the hose and regulator assembly that is
supplied with your LP gas grill.
· Use of this LP gas grill other than for the intended
use, or alteration of the LP gas grill in any way may
not be safe and will void any warranty.
· LP gas is not natural gas. The conversion or
attempted use of natural gas in an LP unit is
dangerous and will void your warranty.
· Never use an LP gas cylinder if it shows signs of:
dents, gouges, bulges, fire damage, corrosion, leak-
age, excessive rust, or other forms of visual external
damage; it may be hazardous and should be checked
by a Liquefied Petroleum supplier. Do not use an LP
cylinder with a damaged valve.
· Never use charcoal in your LP gas grill. Do not use
aerosols or store flammable liquids or materials near
this gas grill.
Selecting a Location
Precautions
•
Never connect or disconnect LP gas cylinder or fittings
while grill is in use or is hot.
•
When the LP gas cylinder is connected, the grill must
be kept outside in a well-ventilated space. Turn off all
of the grill control knobs and the LP cylinder valve
when grill is not in use.
•
Move gas hose as far away as possible from hot surfaces.
