Paragon-X Getting Started Guide
Page 16 of 28
Paragon-X Workflow
From the Workflow buttons:
1.
The first step is to connect to Paragon-X. Click on Start Up then Connect.
2.
Enter the Paragon-X IP address and your username, if required (the default is your PC username)
then click on OK. If failure to connect occurs, check your network connection and host PC network
adapter settings (see details in previous section).
3.
Click on Operating Mode.
4.
Select the traffic type.
Note: available modes will depend on the options fitted (licenced) on Paragon-X:
CES: Circuit Emulation Service, for example, CESoP, SAToP, TDMoIP. (Requires Option 202)
1588v2: IEEE1588v2 advanced analysis features
Enable Master/Slave Emulation. (Requires Option 250 or 252)
Services: Analyse and impair any Ethernet or IP traffic (available on all instruments).
Sync-E: Synchronous Ethernet (Requires Option 213)
NTP: NTP Capture, Header decode & Timing Analysis (Requires Option 404)
Ethernet OAM: OAM capture, overwrite and impairment generation to 802.1ag and Y.1731
(Requires Option 301)
MPLS-TP OAM: MPLS Transport Profile OAM (PTN version using Y.1731) capture, overwrite and
impairment generation (Requires Option 302)
