The USBCNC-INT kit includes a mounting bezel that also acts as a drill jig. Once the installer
has identified where the display should be mounted, the mark the small hole in the center and
drill a hole of the same size. Mount the plate, level and tighten to the cabinet. Please note to use
best method to manage the metal chips created when drilling the holes.
Note the orientation of the bezel. The large hole should be on the left. The large hole allows lay
the RJ11 jack on the display to protrude into the machine’s enclosure. Ensure that the proper
orientation is used before drilling any holes.
With the bracket held in place with a bolt through the smaller center hole, level the bracket and
mark the larger hole on the bracket, this will need to punched or step drilled to this same size.
Drill the four outer holes using the bracket as a drill jig.
Remove the bracket.
Hole saw, step drill or punch out the larger diameter hole. The RJ11 connector of the display will
protrude through this hole. (
McMaster Carr p/n 3789A18, 1 1/8” hole saw can be used
).
This is the smaller hole
in the center. Use this to
hold the bezel in place
while drilling the outer
four mounting holes.
