1142 Radio Portable Manual - O&M Manual V6
Z:\AA MANUALS & INSTRUCTIONS 2017\1142 Radio System\1142 Radio Portable Manual - O&M Manual V6.docx
Page
20
of
21
Exiting the setup mode is done by pressing and holding the two buttons until all four lamps circle
to end this function.
Please note: The pairing mode times out after five
minutes.
The 1123 Global over door lamp panic alarm system
The 1123 Radio over door lamp is used to alert staff to any panic buttons that have been
activated in the vicinity. The 1123 also acts as a repeater sending messages on to the master
panel.
When any panic buttons are pressed, the 1123 unit will begin to flash and a tone will sound.
To silence the 1123 unit, a cancel signal must be sent from an 1142 master panel or from the unit
that triggered the panic (Cancel @ source).
The 1123 unit is powered via a 12V PSU. The PSU is powered from any mains 240V source. The
PSU can be connected to the mains via the supplied plug or a suitable 3amp rated fused spur
(if applicable).
Low Battery Alerts
Left Mini
button
Right Mini
button
Bottom red lamp
Confirm pairing
Right hand
lamps lit
memory full
Add a device
Top two red lamps
Already paired