!
37!
!
Proprietary*Information:*Not*for*use*or*disclosure*except*by*written*agreement*with*Calix.*
©!Calix.!All!Rights!Reserved.!
3.!
In the browser's URL Address box, type the E7-20 management IP address, then press
the
Enter
key. For example, type
192.168.1.1
(default IP address of the E7-20 front
Ethernet management port).
Note:
The web interface operates in secure HTTP mode (HTTPS) by default. Therefore,
you must type
https://
before typing the E7-20 management IP address. You can
change this default setting.
Configuring!the!In)Band!Management!Interface!
The E7-20 is equipped with an in-band management port, to support remote management
over its "in band" Ethernet port interfaces. The in-band management port is accessible from
any of the E7-20 Gigabit Ethernet (GE) or 10-Gigabit Ethernet (10GE) port interfaces,
provided that the port interface is added to the management VLAN. Connection speed
depends on the line rate of the access port (GE or 10GE) as well as the priority assigned to
the management VLAN.
Note:
Calix strongly recommends that you reserve a VLAN for the purpose of management
traffic only and not use it for regular network traffic.
To use in-band management, you must provision the following parameters, which you may
have already done during the initial system turn up procedure:
1.!
Enable the in-band management port.
2.!
Configure the management port with an IP address.
3.!
Provision a management VLAN.
4.!
Assign the port interface to the management VLAN.
Note:
If all of the E7-20 management ports are enabled, their IP addresses must belong to
different subnets.
To!configure!the!in)band!management!interface!
1.!
If the management VLAN does not already exist, you must create it before continuing.
See Creating VLANs in the
Calix E7 User Guide
for instructions.
2.!
On the Navigation Tree, click
E7
.
3.!
In the work area, click
Management
>
Inband Mgmt Interface
to display the port
settings for Management Configuration 1.
4.!
Modify the in-band management port settings as follows:
a.
!
In the Admin Status list, select
enabled
to enable in-band management access, or
select
disabled
to disable it.
b.
!
In the IP Address box, type an IP address for the in-band management port.
