77
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
© Calix. All Rights Reserved.
Parameter
Description
Valid Options
Matching Tag
Specifies the match criteria. If you select Enter Value, then you must also
specify the VLAN ID value to match. VLANs can be specified by name, or by
numeric VLAN ID.
(VLAN IDs 1002-1005 are reserved for E-Series operation.)
ignore, any, untagged,
priority,
Enter Value (then enter a
VLAN ID 2-4094)
Matching pbit
P-bit value that specifies the VLAN priority value to match.
pbit-0 to pbit-7, pbit-any,
or leave blank
Action Performed*
Specifies whether to add, change, or add and change tags to incoming
packets.
add-tag
add-2-tags
ch-tag
add-and-ch
S-VLAN (Outer Tag)*
New VLAN ID.
(VLAN IDs 1002-1005 are reserved for E-Series operation.)
2-4093
C-VLAN (Inner Tag)
New VLAN ID.
(VLAN IDs 1002-1005 are reserved for E-Series operation.)
Note:
This parameter only applies if the Action Performed selection is "add-
2-tags" or add-and-change.
ignore, any, untagged,
Enter Value (then enter a
VLAN ID 2-4093)
* Required field
To add VLAN tag actions to an E-Series Ethernet interface
1.
On the Navigation Tree, click
Interfaces
.
2.
Double-click the specific interface where you want to add a tag action.
Note:
The tag actions only apply to interfaces assigned as edge or access link.
3.
Click the
Tag Actions
tab.
4.
From the menu, click
Create
.
5.
Reference the table above to configure the parameters.
6.
Click
Create
.
For CLI:
To add a tag to all packets on an interface:
create tag-action add-tag <vlan ID> interface <interface name>
To add a tag only to the packets that match specific criteria on an interface, append one
of the following to the command above:
match-pbit <pbit value>
match-tag <vlan ID>
match-tag <vlan ID> match-pbit <pbit value>
Note:
Using match-pbit criterion without using match-tag criterion will match only
802.1P packets (reserved VLAN 0).
To add an outer tag and an inner tag to untagged traffic on an interface:
create tag-action add-2-tags outer <vlan id> inner <vlan id> interface
<interface name> match-untagged
