12
Use Remote Control
Device
Figure 12
There are two modes to set Remote Control: Self-study Mode& Numeric Mode
Self-study code may be set up to 60 groups.
A.
Self-study mode corresponds to receiver in control board. Press and hold STUDY key
for 3 seconds until flashing light turn to solid bright, press any key on Remote Control until
STUDY light turn to flashing again, setting done. Repeat above if additional code needed.
B.
Existing Codes removal. Press STUDY key and hold for 8 seconds, watching light state:
flashing-solid-flashing, setting done. All existing Self-study codes have been removed.
Numeric Mode
A.
First to turn SW9 key to ON position, now control board activated.
B.
Make a combination of code. On SW8, Set an 8-digi combination to match identical 8-digi
combination on Remote Control. Note: each switch could be placed on up, middle and low
position. No limit of groups of combinations.
C.
On switch SW10, KEY 1 and KEY 2 are used for 2-buttom model of remote controls. Note: if
KEY 1 code was set corresponding with BUTTON ONE on remote control, then KEY 1 will NOT
work with BUTTON TWO on remote control.
