User Manual - Rev AJ
California Instruments
3
101.5 105.5 105.5 105.5
Frequency
380 390 360 360
Table
l Vol
uency
Standard/Group
RTCA Group1 Group2 Group3
9-1:
orma
N
tage
Freq
and
Minimum
1
122 122 122 122
Voltage
3
120.5 120.5 120.5 120.5
Frequency
420 410 650 800
Table 9-2: Normal Voltage and Frequency Maximum
This test will set the voltage and frequency to levels defined by Table 9-1. The test will last for 30
nd 3 using the Voltage setting from Table 9-2
he
←
key (backspace) will terminate the test at any time.
VOLT FREQ MAX
This test will set the voltage and frequency to levels defined by Table 9-2. The test will last for 30
minutes. The test will be repeated for the EURO standard using the Voltage setting from
Table 9-
nd the freq
y from
le 9-2
y in lo
eratio
l terminate the test
at any time. Group execute trigger will terminat
remain at 115 volts. The
y time.
VOLT U
up2 Group3
minutes. The test will be repeated for the Group 2 a
and the frequency from Table 9-1. T
1 a
uenc
Tab
. The CLR Ke
cal op
n wil
e the test remotely. The unselected phases will
←
key (backspace) will terminate the test at an
NBALANCE
Standard/Group
RTCA Group1 Gro
Voltage
offset
6 6 6 9
Frequency 400
400 360/650 360/800
Table 9-3: Normal Voltage Unbalance
This test will chang t
e he output voltage for each phase from 115 volts to 115V + offset. Refer to
Table 9-3 for the offset value and the Frequency. The test will last 30 minutes. The test will be
repeated for a second Frequency if applicable. The test can be terminated at any time.
The
←
key will terminate the test at any time.
WAVEFORM DISTORTION
This test will generate a 5% THD voltage distortion on the output voltage waveform. The
distortion is generated by using a clipped sine wave. The test will last for 30 minutes. The
←
VOLTAGE MO ULA
This test requires a numeric value entry equal to the modulation rate in Hz. This entry value
must be between 1 Hz and 200 Hz. The amplitude modulation is calculated based on the
modulation rate as defined in Figure 9-4. This test will last for 2 minutes.
key (backspace) will terminate the test at any time.
D
TION
MX
Series
194