![background image](http://html1.mh-extra.com/html/california-instruments/801p-series/801p-series_user-and-programming-manual_3434434064.webp)
User and Programming Manual - Rev H
California Instruments
May 2000
P Series
56
•
A response message consists of data in a specific SCPI format sent from the AC source
to the controller. The AC source sends the message only when commanded by a program
message called a "query."
12.2.3 The SCPI Command Tree
As previously explained, the basic SCPI communication method involves sending one or more
properly formatted commands from the SCPI command tree to the instrument as program
messages. The following figure shows a portion of a subsystem command tree, from which you
access the commands located along the various paths (you can see the complete tree in
appendix A).
Root
[:SOURce]
:VOLTage
[:LEVel]
:CURRent
:RANGe
:SYSTem
:REMote
:ERRor
:LIMit
:FREQuency
:LOW?
:HIGH?
Figure 12-1: Partial Command Tree
The Root Level
Note the location of the ROOT node at the top of the tree. Commands at the root level are at
the top level of the command tree. The SCPI interface is at this location when:
•
the AC source is powered on
•
a device clear (DCL) is sent to the AC source
•
the SCPI interface encounters a message terminator
•
the SCPI interface encounters a root specifier
Active Header Path
In order to properly traverse the command tree, you must understand the concept of the active
header path. When the AC source is turned on (or under any of the other conditions listed
above), the active path is at the root. That means the SCPI interface is ready to accept any
command at the root level, such as SOURCe or MEASurement.
If you enter SOURCe the active header path moves one colon to the right. The interface is now
ready to accept :VOLTage :FREQuency, or :CURRent as the next header. You must include
the colon, because it is required between headers.