CALIFORNIA ACCENT LIGHTING, INC.
2034 E. Lincoln Ave. #431, Anaheim, CA 92806
ph. 800.921.CALI (2254) or 714.535-7900 \ fx. 714.535.7902
[email protected] \ calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
Installation Instructions
market
LITE
™
ML
2000-CM
8 of 11
Step by Step (cont.)
10.
Open power plug terminal to access screws inside.
11.
Connect neutral wire to silver screw terminal and connect hot
wire to brass screw terminal.
12.
Reassemble power plug.
Brass
Terminal screw
Silver
Brass
Neutral wire
Hot wire
Silver
Fasten screws to secure
wires to power plug
13.
Conduct continuity test.
14.
Set voltmeter to AC voltage, then test power source before connecting.
15a.
(Dry Location only) Connect power source to power plug.
See page 11 for troubleshooting guide
If a conductive
path is formed
between positive
and negative wire,
the multimeter will
beep. You need to
trouble shoot to
find the short.
If there is no
conductive path, the
multimeter will not
beep.
Troubleshoot
Good
VAC
OFF
VDC
A
COM
Ω
VΩ
VAC
OFF
VDC
A
COM
Ω
VΩ
DCA
OFF
DCV
A
COM
Ω
VΩ
+ -
VAC
OFF
VDC
A
COM
Ω
VΩ
VAC
OFF
VDC
A
COM
Ω
VΩ
DCA
OFF
DCV
A
COM
Ω
VΩ
+ -
Confirm the correct
voltage, depending on
the light strip.
Power source
AC
VAC
OFF
VDC
A
COM
Ω
VΩ
VAC
OFF
VDC
A
COM
Ω
VΩ
DCA
OFF
DCV
A
COM
Ω
VΩ
+ -
GFCI
(by others)
Weatherproof junction box
(by others)
Power plug
ML2000-CM
GFCI
(by others)
Power plug
ML2000-CM
9.
Separate wires and strip 1/4” to expose conductor wires.
TIP:
Hot wire has ridges along the jacket.
Neutral wire
Hot wire
15b.
(Wet Location only) Connect power source to power plug.
NOTE:
Must use weatherproof outlet protector for Wet Location.
