CALIFORNIA ACCENT LIGHTING, INC.
2034 E. Lincoln Ave. #431, Anaheim, CA 92806
ph. 800.921.CALI (2254) or 714.535-7900 \ fx. 714.535.7902
[email protected] \ calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
Installation Instructions
lip
LEDs
™
LLED
8350-UC
8 of 11
Mounting Channel (Dry Location)
1.
Measure area where LLED8350-UC will be installed.
RECOMMENDATION:
Use chalk line to ensure a straight installation.
2.
Drill holes as needed with drill bit and countersink.
3.
Screw channel into desired surface using countersink holes.
NOTE:
Surface must be flat.
4.
Remove adhesive backing from lightstrip, then install into channel.
5.
For downward facing applications, install channel clip every 6”.
PUSH
PUSH
PUSH
PUSH
PUSH
PUSH
PUSH
PUSH
PUSH
PUSH
Chalk line
20’
6.
Conduct continuity test.
7.
Set voltmeter to DC voltage, then test power source before connecting.
8.
Connect power source to power connector.
TIP:
If LEDs do not turn on, flip polarity (+,-) or power source connection to
power connector.
See page 10 for troubleshooting guide
If a conductive
path is formed
between positive
and negative wire,
the multimeter will
beep. You need to
trouble shoot to
find the short.
If there is no
conductive path, the
multimeter will not
beep.
Troubleshoot
Good
VAC
OFF
VDC
A
COM
Ω
VΩ
VAC
OFF
VDC
A
COM
Ω
VΩ
+ -
DCA
OFF
DCV
A
COM
Ω
VΩ
+ -
VAC
OFF
VDC
A
COM
Ω
VΩ
VAC
OFF
VDC
A
COM
Ω
VΩ
+ -
DCA
OFF
DCV
A
COM
Ω
VΩ
+ -
Confirm the correct
voltage, depending on
the light strip.
Power source
DCV
VAC
OFF
VDC
A
COM
Ω
VΩ
VAC
OFF
VDC
A
COM
Ω
VΩ
+ -
DCA
OFF
DCV
A
COM
Ω
VΩ
+ -
VAC
OFF
VDC
A
COM
Ω
VΩ
VAC
OFF
VDC
A
COM
Ω
VΩ
+ -
DCA
OFF
DCV
A
COM
Ω
VΩ
+ -
TRA
Power
Source
Power connector
LLED8350-UC
Ensure screw is
flush with channel
Countersink hole
Channel clip
(LLED8350-UC-CP)
Ensure clip is
secured in place
LLED8350
Remove adhesive backing
Ensure lightstrip
is secured in place
Channel
