12
Set summer daylight saving time.
ON/OFF selection: activating
the ON option will enable the
function. Check the disinfection
programming.
Disinfection program setting.
Disinfection mode selection
activated by inlet IN1.
ECO function enable. ON/OFF
selection: Activate the ON option to
enable the function.
Setting the minimum disinfection
temperature, performed on the
enabled probe (see probes T1 and
T2 enable control).
Setting disinfection start day and
time (The segment under the day
indicates its activation).
Setting the minimum time during
which the temperature must remain
above the set temperature during
the disinfection phase.
Setting of maximum time available
in which it is possible to perform
the disinfection.
Setting of the six time bands
that can be set for recirculation
(OUT2 activation)
1-02:00 and 05:59 4-14:00 and 17:59
2-06:00 and 09:59 5-18:00 and 21:59
3-10:00 and 13:59 6-22:00 and 01.59
“Installer Menu” password change.
Access to the "Controls sub-
menu": Zero acquisition, full scale
acquisition, disinfection, thermal
shock, test (opening/closing). For
details of the sub-menu, refer to the
next paragraph.
Indicates the motor position.
Alarm reset. Resets active and
historicized alarms. The "Alarm
Sub-menu" will no longer be
displayed until the next alarm. For
details on the sub-menu, refer to
the relevant paragraph.
Measurement of the associated
valve.
Exit from "Installer Menu"
After a 2 minute time without
touching the knob, the menu
closes automatically
Programming.
Communication protocol parity
setting.
Default ON
Default d2
Default In2
Default OFF
Default 60°C
Default 30 min.
Default 60 min.
Active default on all ranges
Default: Every day 02:00
Default: EVEN
