ITC 220 Base Station, Locomotive & Wayside Radio Transceiver Field Service Guide PN 0046300120 Rev. A
| Page 84
APPENDIX F
— SAMPLE POST RESULTS TYPICAL FOR PROPERLY FUNCTIONING TRANSCEIVERS
+POST 05/22/12 19:34:46
*************** Host Post Log ***************
Board Type
: Base
(or Locomotive or Wayside)
Hardware Revision
: F2
(or F3, etc.)
Serial Number
: 20024
(may be many digits and letters)
HOST: DDR Address Line Test
: PASS
HOST: DDR Data
Line Test
: PASS
HOST: SPI
: PASS
HOST: SDCARD Present
: PASS
HOST: SDCARD Fail Pin
: PASS
HOST: SDCARD Write Protect
: OFF
HOST: SDCARD Access
: PASS
HOST: I2C Controller
: PASS
HOST: I2C Mux
: PASS
(Not applicable for Wayside)
HOST: RTC
: PASS
HOST: BOOT FLASH (C:)
: PASS
HOST: BOOT FLASH (D:)
: PASS
HOST: DATA FLASH (E:)
: PASS
HOST: SEEPROM STAMP
: PASS
HOST: CALIBRATION PARAMETERS : PASS
HOST: REG PARAMETERS
: PASS
HOST: ID PARAMETERS
: PASS
HOST: CHANNEL TABLE
: PASS
HOST: SITENAME
: PASS
HOST: DHCP CONTROL
: PASS
HOST: SERIAL NUMBER
: PASS
HOST: FPGA LOAD
: PASS
HOST: DSP LOAD
: PASS