Personal Ambulatory Oxygen System
Provider Technical Manual
20771733 D 34
2. To remove the Power Manager Board, the first step is to cut the tie-wraps that are attaching the two Service Port Wire Harnesses and 9-Volt
Wire Harness to the Power Manager Board. Using a pair of small cutters, snip the end of the two tie-wraps.
Figure 58 Figure 59
3. Next, disconnect all Wire Harness Assemblies that are attached to the Power Manager Board. These Harness Assemblies are circled below.
The Power Manager Board to ATF Wire Harness will also need to be removed if replacing the Power Manager Board.
Figure 60
9-Volt Battery
Wire Harness
Power Manager
Board to Battery
Bridge Board
Wire Harness #2
Power Manager
Board to Battery
Bridge Board
Wire Harness #1
Main
Power Wire
Harness
Power
Manager
Board/Control
Board/Battery
Bridge Board
Wire Harness