- Quattro Technical Information Manual
58
Connecting using the Ethernet port
Ethernet Communication Setup
The Quattro reader can be connected to a PC using an Ethernet cable. In order to correctly operate with
the reader follow the steps above:
1.
Connect the Quattro to the power supply, the power LED will turn on, wait about 30 seconds until you
hear a beep, wait 10 seconds again and the reader is ready to work with the HID profile active.
2.
Plug an Ethernet cable
12
(not provided) into your computer and connect the other end of the Ethernet
cable to the reader. If your private network matches the default network configuration of the reader
(IP address 192.168.0.2) you can connect to it, otherwise you can:
a.
change the network configuration of the reader (see § NETWORK page 19) to connect it to
your network
or
b.
disconnect your PC from your network and connect it to the network of the reader.
3.
Connect the antenna cable to Ant-0 (see §
Java Virtual Machine
The user can write his own scripts in Java code and use the "Package Upload " function of the
section page 20 of the web configuration to upload them on the reader:
The selection of the script to be used among those loaded is done through the "
Code
" option of the §
12
For proper operation of the device:
-
Ethernet cable shall be CAT6 at least (type S/FTP or S/STP)
-
Put two ferrites (P.N. RRC-13-7-23-M-K5B by RICHCO; CAEN RFID ordering code LFAAFFP00004) on the Ethernet cable,
near the reader connector.
