CONFIGURATION USING THE WEB INTERFACE
Quattro Technical Information Manual
17
4
CONFIGURATION USING THE WEB
INTERFACE
Introduction
The reader can be configured via web interface.
The Web Interface is accessible only via the Ethernet connection:
1.
Connect the Quattro reader to the power supply.
2.
Plug an Ethernet cable
2
(not provided) into your computer and connect the other end of the
Ethernet cable to the reader. If your private network matches the default network configuration of
the reader (IP address 192.168.0.2) you can connect to it, otherwise you can:
a.
change the network configuration of the reader (see §
page 19) to connect it to your
network
or
b.
disconnect your PC from your network and connect it to the network of the reader.
By factory default, the Quattro web interface is reachable at the following IP address: 192.168.0.2.
To login, type
root
in the Username text box and
root
in the Password textbox. To change the username
and password please refer to
2
For proper operation of the device:
-
Ethernet cable shall be CAT6 at least (type S/FTP or S/STP)
-
Put two ferrites (P.N. RRC-13-7-23-M-K5B by RICHCO; CAEN RFID ordering code LFAAFFP00004) on the Ethernet cable,
near the reader connector.