INSTALLATION INSTRUCTIONS
(continued)
Single Pole
Thermostat
Single Pole
Thermostat
Single Pole
Thermostat
Single Pole
Thermostat
Single Pole
Thermostat
Single Pole
Thermostat
Single Pole
Thermostat
Single Pole
Thermostat
Single Pole
Thermostat
Single Pole
Thermostat
Thermostat
STEP 3
Reassemble
STEP 4
Tuck wires into wiring compartment cover, and replace one screw previously removed. Replace front heater
cover.
For best results, use a Cadet electronic wall thermostat or an EBKN double pole thermostat kit. It is recom
-
mended that a thermostat be provided for each room. The location of the wall thermostat should be selected
carefully. Thermostats should not be located near drafts from an open doorway or within 18” (45.7cm) of an
outside wall, or in direct sunlight or unusual heat sources. A television set or appliance that builds up heat near
a thermostat will prevent the thermostat from functioning properly. A wiring diagram illustrating typical wiring of
the thermostat is included in the literature provided with the thermostat.
Illustrated in Figures 8 through 12 are wiring diagrams typical of a single unit controlled by a single pole ther-
mostat, a single unit controlled by a double pole thermostat, and two units controlled by a double pole thermo
-
stat.
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12
Single Pole Wall Thermostat Left End Wiring
Double Pole Wall Thermostat Right End Wiring
Single Pole Wall Thermostat Right End Wiring
Double Pole Wall Thermostat Left End Wiring
Connecting
Multiple
Units
Left End
Wiring
240 or 208
volt models
only
120, 240 or 208 volt models
240 or 208 volt models only
120, 240 or 208 volt models
240 or 208 volt models only
Page 4
