• NOTE
: To prevent personal injury always use a licensed electrician to
install new outlets or circuits.
• NOTE
: The hardware for mounting the hanger bracket to the wall or
ceiling is not included.
• Use of the hanger bracket allows the unit to be rotated approximately 45°
in each direction from center and tilted in a range of 45° while suspended
from a wall or ceiling.
• CAUTION
: When turning and/or tilting the heater do not block the exhaust
opening.
INSTALLATION INSTRUCTIONS
4
Figure 3
INSTALLATION WITH HANGING BRACKET
Figure 4
HANGER BRACKET MOUNTING OPTIONS
ceiling mount
wall mount
1. Locate a stud or other suitable
support and install hanger
bracket on wall or ceiling. Select
a location where the control knob
can be easily reached.
2.
Insert carriage bolt into square
opening of heater handle.
3. Slide spacer over the carriage
bolt shaft and insert in hanger
bracket opening and hold them in
position.
4. Slide lock washer and thread
on T-Handle onto carriage bolt,
turning to tighten.
carriage bolt
hanger bracket
T-handle
lock washer
air in
air out
spacer
