8
End Prog
End Programming - Local programming is ended.
Start Dnld
Start Download - Download session is started.
End Dnld
End Download - Download session is ended.
Cancel
Cancel - System is disarmed; Cancel was initiated within 5 minutes of an alarm.
Gnd Flt
Ground Fault - A short to ground has been detected.
Man Test
Manual Test - Bell and/or communicator test while system is in disarmed condition.
Re-exit
Re-Exit - The exit delay has been re-started without disarming the system.
Output Trip
Output Trip - A trip has occurred on an expander auxiliary output.
Data Lost
Data Lost - Communication of a signal has failed (log only event).
Walk-test
Walk-Test - A zone “Walk-Test” mode has been activated.
End Test
End Test - Test has been ended.
Cross-Trip
Cross Trip - The first zone of a cross zone has been tripped (log only event).
Expansion Event
Expansion Event - An expansion module has created an undefined event.
Partial Arm
Partial Arm - Reports a closing in the stay mode.
Listen In
Listen In - A listen in function has been activated.
Service Start
Service Start - Technician is on site.
Service End
Service End - Technician is off site.
Code Entry
Code Entry - A code has been entered.
First Open
First Open - Reports when the first partition is disarmed.
Last Close
Last Close - Reports when the last partition is armed.
Sprnklr
Sprinkler - Instant sprinkler supervisory report
Clock Set
Clock Set - Clock has been reset.
RF Jammed
RF Jammed - A wireless expansion module is jammed
CleanMe
CleanMe - A smoke detector requires cleaning.
U
9 5
SET ELAPSED TIME IN MINUTES SINCE LAST AUTOTEST
1) Enter [
U
]-[9]-[5]
The LCD screen will prompt for a code.
2) Enter [program code]
The LCD will now display the elapsed time screen.
3) Enter [100's digit] -[10's digit]-[1's digit]-[#]
U
9 7
SET SYSTEM TIME AND DATE
1) Enter [
U
]-[9]-[7]
The LCD screen will prompt for a code.
2) Enter [master code]
The date and time will be displayed with the current hour flashing.
3) Use the up and down scroll keys to select the proper hour.
4) Enter the [
U
] key to move to the minutes.
5) Repeat steps 3 & 4 until the entire date is set.
U
0
ADJUST KEYPAD TONE
1) Press [
U
]-[0]
The LCD screen will prompt you to use the scroll keys located on
the right of the display to raise or lower the tone.
2) Use the up scroll key to raise the tone.
Use the down scroll key to lower the tone.
The keypad will emit a continuous tone to allow you to hear the
current selection.
3) When the desired tone is reached, press the [#] key to set this tone and exit the mode.