7
RESETTING YOUR SECURITY CONTROL CENTER
In the event of a system malfunction in the Security Control Center, press the [#] (reset) key
on the keypad control. This should reset the code sequence and restore normal operation. If
the problem persists, call the service number located on page 1 of this booklet for service.
AUDIBLE ALARM SOUNDS
FIRE: Steady siren, pulsing bell (see page 1) or beeping keypad.
INTRUSION & PANIC: Yelp siren, steady bell (see page 1) and beeping keypad.
KEYPAD CONTROL LIGHT INDICATORS
ARMED
RED: On when system is armed; off otherwise. Flashes for alarm memory if alarm
was activated during arming cycle.
READY
GREEN: On when all zones are secure and/or Bypassed and the system is ready
to arm; off otherwise. Flashes for telephone line fault.
INSTANT RED: On when the entry/exit zones are instant; off otherwise.
POWER
RED: On when AC power is on; off otherwise. Flashing when the system standby
battery is low.
ZONES
YELLOW: Flashing means unsecured. Steady means bypassed. Off means
secure.
KEYPAD CONTROL TONES (BEEPS)
A sounder is built into the keypad and may sound for any of the following reasons:
Beeps for all keypresses.
Sounds a continuous tone during the Entry delay time.
Pulses when a day zone is violated while the system is disarmed.
Pulses when a FIRE zone has a trouble condition; there is a low battery, or bell circuit
trouble.
Pulses when the armed status changes and the AC power is off.
Beeps 3 times for trying to arm with the "READY" light off, if "FORCE ARMING" has not
been selected.
Beeps 1 second for the "CHIME" feature.
Beeps 1 second at the end of the exit delay.
Beeps to indicate telephone line fault if selected.
Beeps 1 long beep followed by 3 short beeps to alert you that there are only ten seconds
remaining in the exit delay.
When pulsing, the keypad sounder may be silenced by entering a valid code. The arm/disarm
state of your system will not change when entering a code to silence a pulsing keypad
sounder.
www.ealarm.com.my