CHAPTER 2:
INSTALLATION
Page 2-6
ST-500 INSTALLATION GUIDE
5.
Drill a hole in the cable for the center probe. Insert the drill end of
the hand coring tool into the center hole and apply pressure while
twisting the coring tool clockwise (see Figure 2-5). When the
coring tool turns freely, remove the coring tool. (The coring tool
has a stop to prevent over-drilling.) Remove debris by holding the
tap with the cable bed facing down and tapping lightly on the side
of the tap. Do not blow into the hole to remove debris. Examine the
hole to be sure that it is free of debris.
Figure 2-5. Drilling the Ethernet Cable
6.
Install the center probe using the nut driver end of the coring tool
(see Figure 2-6). Insert the center probe into the hole in the
underside of the cable bed and tighten until snug.
CORING
TOOL
CABLE
BED
