Cabletron Systems SPECTRUM FRX6000, Maintenance Manual

Page: 65 / 78

Conf iguring LAN Card Software B-3
Parameter Setting
Zero Wait State Enabled No
Plug and Play Adapter Disabled
I/O Base Address
1
1st/only card:
240
hex
2nd card:
280
hex
IRQ
1st/only card:
10
2nd card:
5
2
Boot ROM Disabled
Network Interface Auto Media Detect
1
The card requires 32 contiguous I/O addresses (e.g.,
240-260
).
2
If card 0 is IBM Token Ring and card 1 is SMC Ethernet, the IRQ
for the SMC card will automatically be set to
10
.
9. Save the configuration, then back out of the setup by selecting
Previous
, then
Exit
.
SMC TokenCard Configuration
1. Make sure the card’s jumpers are configured as shown in
Figure A-3 .
2. Boot the unit with a DOS (5.0) system disk.
3. At the
A:>
prompt, insert the SMC SuperDisk Version 5.0, then
type
ezstart
and press
[Enter]
. The EZStart main menu will be
displayed, showing the current configuration of any installed
SMC Token Ring adapter(s).
4. If there are two Token Ring cards installed, select the adapter
number (
Select Adapter
).
5. Select
Custom
, then configure the card as follows:
Card 0
1
Card 1
I/O Base Address 240
hex
2
280
hex
2
IRQ 10 5
RAM Base Address C800
hex
D800
hex
ROM Enabled None None
Network Interface 4/16 UTP/STP 3 4/16 UTP/STP 3
Early Token Release Yes Yes
1
IIf the node contains only one LAN card, it must be card 0.
2
The card requires 32 contiguous I/O addresses (e.g.,
240-260
).
3
The selection of UTP or STP can be changed later by rerunning
the setup program.