Cabletron Systems SmartSwitch Router, User'S Reference Manual

Page: 38 / 338

Chapter 1: SSR Product Overview
38 SmartSwitch Router User Reference Manual
To exit Configure mode and return to Enable mode, use one of the following commands:
Boot PROM Mode
If your SSR does not find a valid system image on the external PCMCIA flash, the system
might enter programmable read-only memory (PROM) mode. You should then reboot the
SSR at the boot PROM to restart the system. If the system fails to reboot successfully,
please call Cabletron Systems Technical Support to resolve the problem.
To reboot the SSR from the ROM monitor mode, enter the following command.
pvst - Configure Per Vlan Spanning Tree Protocol
(PVST)
qos
- Configure Quality of Service parameters
radius - Configure RADIUS related parameters
rate-limit - Configure rate limits for flows
rdisc - Configure Router Discovery Protocol
rip - Configure Routing Information Protocol (RIP)
rmon - Configure RMON related parameters
sfs - Configure SecureFast Switching (SFS) parameters
smarttrunk - Configure SmartTRUNK
snmp - Configure SNMP related parameters.
stp - Configure STP parameters
system - Configure system-wide parameters
tacacs - Configure TACACS related parameters
tacacs-plus - Configure related parameters
vlan - Configure VLAN-related parameters
web-cache - Configure web caching parameters
Special configuration mode commands:
clear
- Show configuration commands
diff - Compare active configuration against another
configuration
erase
- Erase configuration information
negate - Negate a command or a group of commands
using line numbers
no - Negate matching commands
save - Save configuration information
search - Look up a command in configuration
show - Show configuration commands
Exit Configure mode. exit
Ctrl+Z
Reboot in Boot PROM mode. reboot