H
ARDWARE
I
NSTALLATION
O
VERVIEW
This chapter provides a brief description of the SmartSwitch Remote Access Module hardware
installation process including instructions for:
•
installing the 9W006/9W007 module in to a SmartSwitch 9000
•
connecting the module’s cabling
In case you need to restart the module during installation, instructions are also included for
restarting the module
.
I
NSTALLING
THE
S
MART
S
WITCH
R
EMOTE
A
CCESS
M
ODULE
This section contains
instructions for unpacking
the SmartSwitch Remote Access Module, then
guides you through
installing the module into an SmartSwitch 9000.
Instructions are also provided
for resetting the module.
U
NPACKING
THE
S
MART
S
WITCH
R
EMOTE
A
CCESS
M
ODULE
Unpack the SmartSwitch Remote Access Module as follows:
1.
Remove the shipping box material covering the SmartSwitch Remote Access Module.
2.
Carefully remove the module from the shipping box. Leave the module in its non-conductive
bag until you are ready to install.
3.
Attach the disposable grounding strap to your wrist and to a proper ground (refer to the
instructions outlined on the grounding strap package).
4.
After removing the module from its non-conductive bag, visually inspect the device. If you
notice any signs of damage, DO NOT install the module. Contact Cabletron Systems Technical
Support immediately.
Only qualified personnel should install the SmartSwitch
Remote Access Module.
!
CAUTION
The SmartSwitch Remote Access Module and the host
SmartSwitch 9000 are sensitive to static discharges. Use a
grounding strap and observe all static precautions during this
procedure. Failure to do so could result in damage to the
SmartSwitch 9000 or the module.
