USER’S GUIDE
106 SmartSwitch Remote Access Module
3.
If you have entered the call device or the call peer command correctly, follow the set up and
actions listed below.
Set Up:
1.
Enable the call trace messages by issuing the
trace on
console command.
2.
Erase the current system messages (issue the
er
console command).
3.
Initiate a call to a remote device by issuing the
call device <device name>
console
command.
4.
Display the system messages (issue the
dr
console command).
5.
Look for the following call request messages among the system messages.
Out - CALL RQST ACK Call Id=<call Id> Rate=<data rate> Slot=<slot#>
Port=<port#> Chans=<bearer channel map> TN=<telephone number di-
aled> Ces=<communication endpoint suffix> ConnId=<connect Id
In - CALL RQST ACK CallId=<call Id> Slot=<slot#> Port=<port#>
CES=<ces> ConnId=<connection Id>
In - PROCEEDING Call Id=<call Id> Slot=<slot #> Port=<port #>
Chans=<bearer channel map> Ces=<communication endpoint suffix>
ConnId=< connect Id>
In - CONNECT Call Id=<call Id> Slot=<slot#> Port=<port #>
Chans=<bearer channel map> Ces=<communication endpoint suffix>
ConnId=<connect Id>
Action:
1.
If the system does not report a call request message for the remote device, then the system did
not attempt to make a call. Check to see if there is enough call resources (lines, channels,
supported connections) to make the missing call. For example, if your system supports only
one BRI line, and you have no hunt groups, then only two active connections are possible. The
system would not attempt to make a third call.
If this is not the case, contact Customer Support.
2.
If the system reports a call request message but it does not connect, then the system attempted
to make a call. Check to see if the remote device has already completed the installation and
verification processes, and is currently running with no active errors.
If there are no problems with actions 1 and 2, proceed to action 3.
3.
Check for the following system messages:
In - accept <#,#>
In - disconnect <#,#> - <disconnect cause>
If the system reports these messages, then the network disconnected the call attempt. For the
disconnect cause meaning, refer to the
Cause Code
table. If help is necessary to resolve the
reported disconnect cause, write down the “disconnect cause” and call your phone company
(carrier) to report the problem.
