9W006 and 9W007 219
S
YSTEM
C
OMMANDS
IPX Routing Commands
ip stats
Displays the current IP related statistics. Refer to
IP Statistics
, for a list of available statistics and
their definitions.
IPX R
OUTING
C
OMMANDS
IPX routing must be enabled before these commands can be used.
The following commands are used to display IPX routing information:
ipx ipxwan clear
Clears IPXWAN statistics.
ipx ipxwan stats (device)
Displays system-level IPXWAN statistics when device name not specified:
Displays Negotiation Parameters when device name specified and connected:
ipx diag <host ipx address> [timeout]
Tests device connectivity to specified IPX host by sending out a diag packet. If connection is up,
host sends a message in response to this packet to confirm receipt. The parameters for this
command are:
host ipx address
IPX address for the host, in <network number>:<node number> format. The network number
is a hexadecimal number up to eight digits in length. The node number is the host’s MAC
address. For example, if the assigned network number of “AAAA,” and the host has a MAC
address of 40AA68965439. For this example, you would enter “AAAA:40AA68965439” for the
host IPX address.
timeout
Optional parameter that indicates the number of seconds to wait for a reply. The valid range
for the time out value is 1 to 60 seconds. The default value is 10.
IPXWAN Statistics
Timer Request
=
Timer Response
=
Information Request
=
Information Response
=
Thruput Request
=
Thruput Response
=
Delay Request
=
Delay Response
=
NACK Sent
=
NACK Received
=
Bad Packets
=
WAN Statistics for device “xxxx”
Negotiation Parameters:
IPX Network Address =
IPX Node Number =
Telebit Compression =
Protocol =
WAN Link Delay =
