SmartSwitch 6500 User Guide 3-11
IP Over ATM and LANE
Creating an Emulated LAN
are ANDed together. For example, if three join policies are create, each with the same priority value, a client requesting
LANE services must meet the criteria of all three policies to be assigned an ELAN. If the client fails to meet the
requirements of all three policies, the policy with the next lowest priority value will attempt to assign the client to an
ELAN.
Use the
add lecselanpolicy
command to create ELAN join policies. The following is an example of creating an
ELAN join policy based on the By Packet Size policy.
Smart6500 # add lecselanpolicy
PolicyIndex() : 2
< Can be any value other than one (1)
Type() : ?
< Use
?
to see possible types
ELAN Policy Type (Values from 1 to 7 representing, in order, the policies BestEffort, byATMAddress,
byMacAddress, byRouteDescriptor, byLANType, byPacketSize and byELANName).
Type() : 6
< Specify type 6, assign ELAN by packet size requested by client
Priority() : 1000
< Weight the policy at 1000
Smart6500 #
Note
The lower the numerical value of a priority, the higher the priority. In the example
above, a priority value of 1000 was specified. Subsequently, This policy will be
tried before Best Effort (policy value = 65001).
Use the
show lecselanpolicy
command to show the newly created ELAN join policy.
Smart6500 # show lecselanpolicy
Index Assignment Policy Priority Value
==============================================================================
1 Best Effort (Proprietary) 65001
2 By Packet Size 1000
< The created policy, its index number, and its priority
Smart6500 #
Note
In the example above, index 2 (or greater) was used because the
Best Effort
policy reserves index one.
The LECSELANLEC Table
Many of the ELAN join policies use the information supplied by the
add lecselanlec
command. Use the
add
lecselanlec
command to create a list of clients and to assign the ELAN each client should join.
Note
You can also assign a TLV set to be used by the client on the specified ELAN.
Clients are identified within the
lecselanlecs
list by one (or a combination of) the following attributes:
•
ATM address
•
MAC address
•
Token Ring route descriptor (segment ID and bridge number)
Summary of Contents for SmartSwitch 6500
