Cabletron Systems SmartStack STS16-20FRM, Installation And User Manual

Page: 109 / 260

95
Switch Configuration SmartStack STS16-20RM/STS16-20FRM Token Ring Switches, P/N: 9032957-01
If more ports have the same priority value assigned, the lowest port number will be
selected.
➽
Note! All bridge relay functions in the switch use the same bridge identifier. As a
consequence, you must not divide one switch into two or more VLANs by
connecting them together and using the spanning tree protocol. The tree will
collapse since the same bridge will be seen in several places in the network.
IEEE 802.1D Spanning Tree Protocol (STP)
When the IEEE 802.1D Spanning Tree Protocol is active, a port within that domain
will require several seconds to make the transition from the blocking state to the
forwarding state, when the port is initially activated (e.g. joins an existing ring or
activates a dedicated link.) Some client or server applications may attempt to
establish session activity during this time, resulting in error messages indicating a
connection failure. These applications should be configured to wait at least 30
seconds after the LAN link is active, before attempting to establish session activity.
This delay can be reduced by modifying the 802.1D Spanning Tree Protocol default
parameters.
If STP is enabled on a dedicated port, and a station is attached to it, it takes at least
30 seconds for the port to start forwarding frames, when default STP parameters are
used. The client and server stations may have given up before then and the first
many packets are lost.
In general, STP should not be enabled on ports, which are intended for dedicated
stations. Shared media do not have the same problem, because the port will stay
attached to the Hub, even though all stations have closed.
Another reason for not enabling STP on dedicated ports is that the spanning tree
domain will go into Topology Change state each time a station opens or closes. This
will cause the whole spanning tree domain to use short aging timers, which means
that all address tables will be trashed. The result is a lot of unknown station
broadcasts, before the tables converge again.
To disable STP on a port, select the STP Mode Forwarding for this port. Refer to
the “STP Mode” parameter on page 103.