2-4
Unpacking and Installing Your ELS10-26
Table 2-2 describes the ELS10-26 buttons.
2.2 INSTALLING AN FEPIM
The ELS10-26 provides a slot for a Cabletron FEPIM (Fast Ethernet
Port Interface Module). The ELS10-26 is shipped without an
FEPIM. To install an FEPIM, follow the procedure below:
1. Remove the power cord.
2. Remove the cover of the ELS10-26.
3. Remove the two screws securing the plate on the side of the
FEPIM slot.
4. Install the FEPIM as shown in Figure 2-2. Ensure that the rear
connector is seated firmly before tightening the three
mounting screws.
5. Replace the plate and two screws on the side of the FEPIM
slot.
6. Replace the cover of the ELS10-26.
Table 2-2. Description of ELS10-26 Buttons
Button
Function
Status
Cycles through the Segment Status options (TX, RX,
Act, Col, FDX, 100, MON, and Usr) for all ports. The
right-hand port status LEDs of the ports you are
monitoring are activated based on what function you
chose with the Select button.
Reset
Restarts the ELS10-26.
Only qualified personnel should perform installation
procedures.
Summary of Contents for SmartSTACK 10 ELS10-26
