Cabletron Systems MMAC-Plus 9A000, User Manual, Page: 119 / 180

B-1
APPENDIX B
SCP Diagnostics
The tests provided in this section are very specific diagnostics that are only to
be run if you have determined that there is a problem with your SCP. The
diagnostics for the SFCS-200WG, SFCS-200BX, and SFCS-1000 are described
first.
B.1 SFCS-200WG, SFCS-200BX, SFCS-1000 Diagnostics
If you have determined that there is a hardware problem on a switch control
processor (SCP), run the SCP diagnostics that are available by connecting a
terminal device to that SCP’s serial port.
NOTE:
These diagnostics will only test the
individual SCPs, not the switch fabrics
themselves.
NOTE:
All AMI sessions should be closed before
these test are run.
NOTE:
It is recommended that you back up your
CDB before running any tests that check the
FLASH and/or the SRAM. The chips are
saved before testing each one and then
restored. However, if a power failure would
occur or if the switch were rebooted during
the test, some of the data may not be restored
properly.