Selecting the Port Administrative Status
ESXMIM/ESXMIM-F2 Local Management Guide
Page 8-3
8.3
SELECTING THE PORT ADMINISTRATIVE STATUS
To select the bridge port administrative status, perform the following
steps:
1. Use the arrow keys to highlight the [BRIDGE_PORT X] field.
2. Press SPACE bar or BACKSPACE to select the bridge port you want
to configure. The selected bridge port appears in the Bridge Port
Admin Status field.
3. Use the arrow keys to highlight the BRIDGE PORT ADMIN
STATUS: PORT XX - - > ALL PORTS [ENABLED] field.
4. Press SPACE bar or BACKSPACE to select ENABLE or DISABLE.
For example, the following bridge setup indicates that bridge port 01
is configured to bridge traffic to all ports:
BRIDGE PORT ADMIN STATUS: PORT 01 - - > ALL PORTS
[ENABLED]
5. Use the arrow keys to highlight the SAVE command field.
6. Press ENTER. The Event Message field at the top of the screen
displays “SAVED OK”.
Summary of Contents for ESXMIM
