Cabletron Systems CSX200 CyberSWITCH, User Manual

Page: 71 / 261

CSX200 Configuration with QuickSET
CSX200 Family User’s Guide 57
Table 7 shows the line configuration information determined by your service provider. The
CSX200 factory default settings are in bold.
This section describes the fields in the Wide Area DDS configuration window.
DDS Line Mode —
Displays the DDS Line Mode. The selections for this field are DDS-PRI 56K
(primary) and DDS-CC 64K (clear channel). This information is determined by the service
provider. The default setting is DDS-PRI.
DDS Clock Source — Displays the DDS clock source. The selections for this field are either
Loop-Timing or Local-Timing. The Loop-Timing setting allows the CSX200 to receive its timing
information from the service provider. The Local-Timing setting allows the CSX200 to generate
its timing information internally. If DDS-CC 64K was chosen for the DDS Line Mode then this
field must be set to Loop-Timing. The default setting for this field is Loop-Timing.
DDS Loop Back —
Displays the internal loopback as either Line Loop or No Loop. Line Loop is
reserved for network diagnostics only. The default setting is No Loop.
Protocol —
Displays the active protocol for the Wide Area DDS interface. The selections for this
field are either Frame Relay or PPP. The default setting for this field is PPP.
Link Management Protocol —
If Frame Relay is the selected protocol, this field displays Q.933
Annex A and T1.617 Annex D. The default for Frame Relay is T1.617 Annex D. This field is
grayed out and not used for PPP.
Once the Wide Area DDS configuration is complete, click on the Next>> button, and go to the
Bridging and Routing Configuration section of this guide.
Table 7 Telco Configuration Information
Configuration Information
Required by User Configuration Information
Supplied by Service Provider
DDS Line Mode DDS-PRI or DDS-CC
DDS Clock Source Loop-Timing or Local-Timing
DDS Loop Back No Loop or Line Loop