Cabletron Systems 2H23-50R, User Manual

Page: 118 / 182

Chapter 5: Local Management
5-68 2H23-50R/2H33-37R User’s Guide
NETWORK# (Read-only)
Indicates the network on the connector selected in the CONNECTOR
field.
Table 5-9 shows the association between the CONN and Network
Ports on the device.
LINK STAT. (Read-only)
Displays the Link status (Link or No Link) of the port.
CURRENT OPER. (Read-only)
Displays the current operating mode of the port.
MODE DESIRED OPER. (Selectable)
This field steps through the following operating mode options: Auto-Neg
(Auto Negotiation), 10Base-T, and 100Base-TX.
• When Auto-Neg. is selected, the port Auto-Negotiates with the device
to which it is attached to determine its Operating Mode (10 Mbps or
100 Mbps).
• When 10Base-T is selected, the port is forced to operate in standard
Ethernet mode (10 Mbps) only.
• When 100Base-TX is selected, the port is forced to operate in Fast
Ethernet mode (100 Mbps) only.
To set the port operating mode, refer to Section 5.19.1 .
Table 5-9 CONN/Port Organization
2H23-50R or 6H123-50 2H33-37R or 6H133-37
CONN 1 = Network Port 1, 10 Mbps
Network Port 2, 100 Mbps
CONN 1 = Network Port 1, 10 Mbps
Network Port 2, 100 Mbps
CONN 2 = Network Port 3, 10 Mbps
Network Port 4, 100 Mbps
CONN 2 = Network Port 3, 10 Mbps
Network Port 4, 100 Mbps
CONN 3 = Network Port 5, 10 Mbps
Network Port 6, 100 Mbps
CONN 3 = Network Port 5, 10 Mbps
Network Port 6, 100 Mbps
CONN 3 = Network Port 7, 10 Mbps
Network Port 8, 100 Mbps
HSIM = Port 7