Cabletron Systems 2000, Getting Started Manual, Page: 69 / 92

SmartSwitch Router 2000 Getting Started Guide 69
Chapter 3: Software Installation and Setup
2. Use the following command to verify that the SSR 2000 can reach the DNS server by
pinging the server, as shown in the following example:
3. Ensure that you are in Configure mode by entering the configure command in the
CLI.
4. If you have not done so already, use the interface add ip command to set the IP
address and netmask for the en0 Ethernet interface, as shown in the following
example:
Note: The en0 interface is automatically created by the system and is reserved for
the SSR 2000’s management port.
5. Use the following command to specify the domain name for which the DNS server(s)
have authority:
where <domain-name> is your specified domain name (example:
cabletron.com
).
6. Use the following command to “add” one or more DNS servers to the SSR 2000:
where <IP-address> is the IP address of the DNS server. You can specify up to three
DNS servers.
Note: If you specify more than one IP address, you must separate the addresses
with a space and surround them with a single pair of quotes. You do not need
to surround a single IP address with quotes.
7. Enter the save active command to activate the commands and enter yes or y to
activate the changes.
ctron-ssr-1# ping 10.50.11.12
PING 10.50.11.12 (10.50.11.12): 56 data bytes
64 bytes from 10.50.11.12: icmp_seq=0 ttl=255 time=0 ms
--- 10.50.11.12 ping statistics ---
1 packets transmitted, 1 packets received, 0% packet loss
round-trip min/avg/max = 0/0/0 ms
ssr(config)# interface add ip en0 address-netmask 10.50.11.22/16
system set dns domain
<domain-name>
system set dns server
["]<IP-address> [<IP-address>] [<IP-address>]["]