4 Bay MULTI HDD BOX User Guide
8
Raid Mode Setting
RAID mode setting via RAID switch
1.
Power on the case.
2.
Check and make sure all HDDs are installed and all HDD LEDs light up.
3.
Connect the case to PC via USB or eSATA cable(1 cable only). Make sure HDD LED
light up.
4.
Select HDD Mode from below table by adjusting “Raid Switch”, which is located at
the back of the case.
5.
Pin and hold “RAID Reset” for 3~5 seconds. Then HDD mode will change according
to the selection.
6.
After setting RAID mode, please initialize the HDD again to have the HDD workable.
Please refer to Page.18 for initializing a hard disk.
7.
Format HDDs before they are ready to use.
Note:
Refer to Hard Drive Formatting Guide in the below session for detailed
instructions.
After setting the RAID mode, you can look over the JMicron HW RAID Manager
for checking if you have the correct RAID mode.
RAID Reset
RAID Switch
Summary of Contents for 3.5"
