Caberg GHOST, Manual

Page: 9 / 20

ENG
5. Instruction to remove the washable inner lining
5.1 Open completely the whole mask & visor part.
5.2 Unhook the fixing button on the cheek pad. Do the same step on the other
side. (picture_09).
5.3 On both sides, slip off the chin strap from the loops. (picture_10).
5.4 Starting form the neck pad protection, release the inner lining by pulling
slightly towards the inside of the helmet. (picture_11).
5.5 Remove completely the inner lining by pulling down the lining plastic frame
on the front. (picture_12).
INNER LINING CLEANING INSTRUCTION:
HAND WASH ONLY. Scrub by hand with neutral soap and water no hotter than
30°C.
Rinse with cold water. Do not wring. Dry at room temperature.
Never wash the lining in the washing machine.
Never use petrol or other solvents to clean the lining.
6. Instruction to assemble the washable inner lining
6.1 Open completely the whole mask & visor part
6.2 Place the lining inside the helmet
6.3 Slip the chin strap through the cheek pads loops(picture_13).
6.4 Insert he lining plastic strip frame on the front between shell and EPS (pic-
ture_14). Do the same operation for the plastic frame on the neck side(pic-
ture_15) lastly fasten the buttons on the back of the cheek pads.
7. Instruction to assemble and remove the “RAIN COVER” caps (available
ONLY for the version GHOST DOOM).
7.1 Gently unhook the rear snap of the google strap loop.
7.2 Pull out the 4 rainproof cover caps from the inner pocket (picture_16). Hook
up again the google strap loop snap.
7.3 Place the 4 rainproof cover caps “RAIN COVER” on the holes of the shell
with a simple pressure. (picture_17).
7.4 To remove the 4 “RAIN COVER”, pull up slightly each cap(picture_18).
7.5 Store the 4 “RAIN COVER” rainproof caps in the inner pocket and then
hook up again the google strap loop snap.
9