Caberg GHOST, Manual

Page: 8 / 20

ENG
1. Instruction to open and close the whole mask & visor part:
1.1 To open the whole mask & visor part pull gently the mask outwards and
then upwards (Picture_01). Without the chin part, pull the lower trim of the
mask. (Picture_02).
1.2 Follow through the whole mask & visor part until complete open position. A
fixing snap should be perceived.
1.3 To close the whole mask & visor part repeat the above operation in reverse
order. Please NOTE: the whole mask & visor part is supported by a spring,
so to slow the quick closing of the whole part, gently guide it by hand.
2. Instruction to remove and mount the nose device:
2.1 Pull slightly upwards the whole mask and visor part
2.2 Release the four fixing pins on the nose device by pulling slightly down-
wards (Picture_03). Start from the lateral fixing pins and then with the ones
in the middle.
2.3 To mount back the nose device repeat the above steps in reverse order.
3. Instruction to remove and install the chin part:
3.1 Remove the nose device following the instruction indicated at point 2.
3.2 Release the four fixing pins on the chin part by pulling slightly downwards
(Picture_04). Start from the lateral fixing pins and then with the ones in the
middle
3.3 To reinstall the chin part repeat the above steps in reverse order.
4. Instruction to remove and install the whole mask & visor part:
4.1 Remove the mechanism covers by pulling slightly the rear “tab” as shown
in picture_05.
4.2 Unscrew and remove the four screws
4.3 Remove the rounded ratchet paying attention to release the upper hook
(picture_06).
4.4 Unhook the two springs and then remove the whole mask & visor part (pic-
ture_07).
4.5 In order to use the helmet without the whole mask & visor part, it is neces-
sary to reposition and fasten the rounded ratchet and cover. (picture_08).
4.6 To reinstall the whole mask & visor part it is necessary to repeat the above
steps in reverse order.
8