9
1-800-732-0144
STEP :: 03
FIT THE BARK CONTROL COLLAR
IMPORTANT: The proper fit and placement of the Bark Control Collar is important for effective operation. The
Contact Points must have direct contact with your dog’s skin.
See page 3 for Important Safety Information.
To ensure a proper fit, follow these steps:
1. Make sure the unit is off.
2. With your dog standing (
3A), center the collar so
the Contact Points are underneath your dog’s neck,
touching the skin (
3B). If your dog has a long or thick
coat, you have two options to ensure consistent
contact: either trim the hair around the Contact
Points or switch to the longer Contact Points
included with your system.
Note: When switching to the longer Contact Points, ensure the o-rings are attached.
3. Check the tightness of the collar by inserting one finger between the end of a Contact
Point and your dog’s neck (
3C). The fit should be snug but not constricting.
4. Allow your dog to wear the collar for several minutes and then recheck the fit. Check
the fit again as your dog becomes more comfortable wearing the Bark Control Collar.
Note: If desired, you may cut off the excess length of the collar strap after properly fitting
the collar.
• You may need to trim the hair in the area of the Contact Points. Never shave the dog’s neck; this may lead
to a rash or infection.
• You should not make the collar any tighter than is required for good contact. A collar that is too tight will
increase the risk of pressure necrosis in the contact area.
3A
3B
3C
Summary of Contents for GUNDOG GS-NB6
Page 15: ...15 1 800 732 0144 ...
