Important: After installation is
completed, remove the aerator. Do
not lose the gasket (1) in the
aerator. Turn on the water supply
and allow both hot and cold water to
run for at least one minute each.
This flushes away any debris that
could cause damage to internal
parts. While the water is running,
check for leaks. Turn off the water
and replace the aerator.
INSTALLATION STEPS: 2-Handle Lavatory Faucet
Shut off water supply at angle stop. Remove
old faucet. Clean sink surface in preparation
for new faucet.
1.
Making the waterline connections:
Use 1/2" IPS faucet connections (2, not
included), or use the coupling nuts (3, not
included) with a 3/8" OD ball-nose riser
(1, not included). Use wrenches when
tightening. Do not overtighten.
Ensure the gasket (1) is on the bottom
of the new faucet (2). Place the faucet
(2) through the mounting holes in the
sink. Secure the faucet (2) to the sink
using the mounting nuts (3) provided.
Hand-tighten only.
Option: If the sink is uneven, use the
silicone under the gasket (1).
2.
Cleaning:
To maintain and protect the fine luster of all products, clean with a soft, damp cloth
only. DO NOT USE detergents or cleansers as they may harm the protective finish.
Model Number: 120461LF / 120463LF / 120464LF
INSTALLATION
Place one end of the spring clip (1) onto the
end of the horizontal rod (2). Insert the
horizontal rod (2) through a hole on the
strap (3). Connect the other end of the
spring clip (1) to the horizontal rod (2).
Insert the lift rod (4) into the strap and
tighten the screw (5).
3.
4.
6.
8.
7.
Install the horizontal rod (2) and the
Tools:
Adjustable Wrench
Groove Joint Pliers
Pipe Wrench
Screwdriver
Thread Sealant Tape
Basin Wrench
Plumber's Putty
Remove the stopper (1) and the flange
(2). Screw the brass nut (3) all the way
down. Push the plastic washer (4) and
the gasket (5) down. Unscrew the pivot
nut (6) from the pop-up body (7) and
remove the seal washers (8). Take off
the spring clip (9) from the horizontal rod
(10). Remove the tailpiece (11) from the
pop-up body (7).
1
3
2
1
3
2
4
5
10
9
6
8
7
11
3
4
2
5
1
3
1
2
4
1
3
2
3
4
2
1
5
1
5. Apply the silicone to the underside of the
flange (2). Insert the pop-up body (1) into
the drain hole from underneath the sink.
Screw the flange (2) into the pop-up body (1).
With the pivot hole (3) facing toward
faucet, use groove joint pliers to tighten
the nut (4), but do not overtighten. Do not
turn the pop-up while tightening the nut,
or sealant may not seal drain. Clean
excess putty. Apply thread sealant tape
to the top threads of the tailpiece (5) in a
clockwise direction as shown and tighten
by hand.
stopper (3) as shown (4). Tighten the
pivot nut by hand (1).
