![background image](http://html1.mh-extra.com/html/cab/wicon-squix/wicon-squix_service-manual_3233235016.webp)
16
16
5
Error Treatment
i
Note!
The following table describes the reasons for error messages which occur repeatedly or permanently.
Message
Error/Reasons
Remedy
Touch guard error
Failure of the touch guard movement
•
Shoulder screws at the guard plate
tightened to hard
Adjust the shoulder screws
•
Washers worn
Replace the washers
•
Guard plate worn
Replace the guide plate
•
Drive defective
Replace the motor touchguard
•
Sensor touchguard defective
Replace the sensor touchguard
•
Cable sensor defective
Replace the cable sensor
•
PCB Control defective
Replace the PCB Control
No label on belt
detected
After a labeling cycle is started no label is
detected on the transport belt
•
Label transfer from the printer failed
Check the peel-off behavior
Adjust the peel positions in the printer setup
and the software
•
Transport module defective
Replace the transport module
•
PCB Spring Contact soiled
Clean the contacts
•
PCB Spring Contact defective
Replace the PCB Spring Contact
•
Contacts at the PCB Sensor Labels
worn
Replace the PCB Sensor Labels
•
Sensor labels defective
Replace the PCB Sensor Labels
•
PCB Control defective
Replace the PCB Control
Product release
failed/
Wrapping failed
Failure of the wrapping unit movement
•
Belt tension not correct
Adjust the belt tension
•
Chuck jaws hard-steering
Removing the winder plate and pulling-off the
cam plate
Checking the movability of the chuck jaws in
the winder plate
•
Drive defective
Replace the motor winder
•
Sensor ReDiameter defective
Replace the PCB Sensor Diameter
•
PCB Spring Contact soiled
Clean the contacts
•
PCB Spring Contact defective
Replace the PCB Spring Contact
•
Contacts at the PCB Sensor Labels
worn
Replace the PCB Sensor Labels
•
PCB Control defective
Replace the PCB Control
Table 2
Error treatment