12
12
3.2 Standard Operation
Switch on the printer.
The cutter performs a synchronization action.
i
Note!
To operate the cutter with continuous material in the printer menu
Setup
->
Labels
->
Label sensor
the setting
Continuous media
has to be
selected. Otherwise no synchronization cut is carried out.
Press
. For synchronization the media will be moved forward and
cut off.
That synchronization is not necessary when the printhead was not opened
between print jobs, even if the printer was powered off between print jobs.
Send a print job.
All labels in the job will be printed without stopping and be cut as chosen in
the software : after each label, after a specific quantity of labels, or at the
end of a print job.
i
Note!
Between the print jobs a direct cut can be released by pressing
on the control panel.
i
Note!
In case the material do adhere in follow of electrostatic charge it's
possible to mount an antistatic brush (Part No. 5977339) on the
printer.
3.3 Cutting on Demand
In the "Cut on Demand" mode the print job will be split into steps, which can
be released separately.
Choose
Printing > Print on demand =
On
.
Send a print job.
Press
.
The first label will be printed and cut.
Press
again to print and cut the next label.
i
Note!
The
function can be released alternatively by an external
START signal when the I/O interface is installed on the printer.
Configuration Manual of the printer.