21
6.2
Mounting the Suction Pads
4
1
2
5
3
6
Fig. 15
Mounting pads
1. Loosen screws (3).
2. Use the adjusting tool (6) included (cab serial No.: 5972857) as shown in the picture to adjust the suction plates.
3. Slide each suction plate (4) over the corresponding driving pin (2) to the adjusting tool (6).
Mount the suction plates (4) so that the L connectors (hose connections) are accessible from the front.
4. Tighten screws (3).
5. Remove adjustment tool (6) downwards.
The lower surfaces must now be aligned at an angle of 0 ° and at a height to each other.
6.3
Preparing the Pad Assembly for Adjustments
1
2
3
Fig. 16
Preparing the pad assembly for adjustments
1. Pull off the tube (1) from the L-connector (2) on the horizontal cylinder.
2. Align the suction pads (3) to the dispense edge of the printer
3. Connect the tube (1) to the L-connector (2).